Texas · Pool Leak Detection & Repair · Updated 2026
Losing more than a quarter inch a day? 35 pool leak detection companies in the Fort Worth area, ranked by rating and review count, with what leak detection and the common repairs cost in Fort Worth. This page shows the top 20.
Ordered by customer rating and review count across the Fort Worth area. Listings include the available rating, contact details and location; confirm current credentials and scope directly.
Dedicated leak companies bring pressure-testing and listening gear; repair companies find most plumbing and fitting leaks and call in a specialist for the hard ones.
Looking for weekly service in general? The Fort Worth pool service directory ranks all 112 maintenance companies in the area.
A full leak detection in Fort Worth — pressure testing every line, dye testing the shell and listening for underground breaks — typically runs $250–$500, with the repair priced separately:
| Job | Typical Fort Worth price |
|---|---|
| Full leak detection (pressure + dye + electronic) | $250–$500 |
| Pressure test only | $150–$300 |
| Skimmer or return fitting repair | $300–$1,200 |
| Light niche / conduit seal | $250–$900 |
| Vinyl liner patch | $100–$300 |
| Structural crack repair (staples, epoxy) | $500–$2,500 |
| Underground plumbing repair | $500–$3,000 |
Texas labor rates are close to the national baseline used for these estimates. Most leaks turn out to be at fittings, the skimmer throat, the light niche or the equipment pad — cheap fixes once found. Underground line breaks that need the deck cut cost the most, so ask how the company pinpoints them before digging.
A 24-hour bucket test tells you whether the loss is evaporation and whether it happens with the pump on or off — the two facts that shape the detection visit.
5 stars from 44 reviews
View Company →Fort Worth market
4.8 average customer rating · 1472 reviews · 35 companies · 5 specialists
See All on the Map →35 pool leak detection companies in the Fort Worth area. 5 are listed as specialists for this work; the rest are pool repair companies that routinely handle it. The ranked companies average 4.8 stars across 1,472 customer reviews. PoolPad orders the list with a weighted score that combines customer rating and review count, so a long track record counts for more than a handful of scores.
Dirt decides budgets here. Blackland clay through Dallas–Fort Worth, Austin's east side, and San Antonio swells and shrinks enough to crack a shell that isn't properly engineered, while the Hill Country and much of Central Texas sits on limestone that turns excavation into a rock-hammer job. A builder who works your side of town prices it right the first time. Soil movement, tree roots and old fittings are the usual culprits; a leak that appears after a drought or a wet season often traces to the ground shifting around the plumbing.
For statewide rankings, city counts and Texas prices, see the Texas pool leak detection directory, or check the nearby cities below.
Run a bucket test for 24 hours with the pump on, then off, and note the difference — losing water only with the pump running points to the pressure side, only with it off to the suction side or shell. Check the pad for wet ground and the backwash line. That information lets the company quote the right test and often shortens the visit.
A full leak detection in Fort Worth, TX — pressure testing the lines, dye testing the shell and electronic listening — typically runs $250–$500, with a pressure test alone at $150–$300. Repairs are priced separately: a skimmer or return fitting $300–$1,200, a light niche seal $250–$900, a structural crack $500–$2,500, and an underground plumbing repair $500–$3,000 depending on how much deck has to be opened. Texas labor is close to the national baseline used for these estimates.
Do a bucket test: set a bucket of pool water on a step, mark both water levels, and compare after 24 hours with the pump running, then repeat with it off. Evaporation drops both marks equally; a leak drops the pool more. Summer evaporation runs roughly a quarter inch a day, more with wind, heat and a spa spillover. Losing an inch or more a day, wet spots around the deck or pad, or air in the pump basket point to a leak.
Usually. Fittings, skimmer throats, light niches, small plaster cracks and vinyl patches are repaired underwater with epoxy, putty or patch kits. Underground plumbing is repaired by cutting a small section of deck, or by relining or rerouting the line. Draining is reserved for large structural cracks or a full resurfacing.
Evaporation alone typically costs an inch or two a week in Fort Worth during March through October, more in hot, dry or windy weather and when a heater or spa spillover is running. Splash-out and backwashing add to it. If you are topping off more than a couple of inches a week, or the autofill runs constantly, get a detection visit — a small leak wastes thousands of gallons and the chemicals in them.
The prime outdoor season in Fort Worth runs March through October — roughly 7 months of comfortable unheated swimming — and pools stay open and running year-round rather than being winterized. Summers run 95–105° for weeks at a stretch, and most of the state swims from March into late October. Pools stay open and running through winter — the trade-off is that chlorine demand and evaporation in July and August are among the highest in the nation.
Excelsior Pool Services & Leak Detection has the highest customer rating on this Fort Worth list at 5 stars across 44 reviews. Evolution Leak Detection & Pool Repair has the largest review count (221 reviews at 4.9 stars). PoolPad orders the list with a weighted score that combines customer rating and review count, so a long track record counts for more than a handful of scores.
Rarely for the leak itself: wear, tear and gradual damage are excluded from most policies. Sudden events — a pipe burst by a freeze, or damage caused by a covered peril — may be covered along with resulting damage to the deck or house. Keep the detection report and photos; some policies reimburse the detection fee when the resulting repair is covered.
A full detection visit usually takes two to four hours: pressure testing each line, dye testing the shell, listening for underground breaks and, if needed, a diver. Simple repairs at fittings are often done the same day; underground plumbing repairs that require cutting and patching the deck take one to three days including concrete cure.
Check pool leak detection in cities near Fort Worth, or open the Texas directory for every listed market in the state.
Claim your free PoolPad listing, check leak detection among your services, and show Fort Worth pool owners losing water that you can find the problem.
