Montana · Pool Repair & Equipment Service · Updated 2026
Compare 2 pool repair companies across Montana for equipment repair and replacement. Ratings, review counts, contact details and 2026 planning prices for the most common jobs are below.
Every pool service company in Montana: see the full directory →
The order uses a weighted mix of customer rating and review count; open a city below for the full local list. Confirm current credentials, availability and scope directly.
There is not a separate city list for Montana yet. Use the statewide results above, or browse the Montana pool service directory.
A diagnostic or service call in Montana typically runs $80–$160, often credited against the repair. The common jobs:
| Job | Typical Montana price |
|---|---|
| Service call / diagnostic | $80–$160 |
| Pump motor or seal replacement | $325–$850 |
| New variable-speed pump, installed | $850–$2,650 |
| Heater repair (igniter, sensor, board) | $150–$525 |
| Heater or heat pump replacement | $2,600–$6,800 |
| Filter rebuild (grids, cartridges, laterals) | $150–$525 |
| Salt cell replacement | $550–$1,150 |
| Automation / controller install | $1,600–$4,200 |
Montana labor rates are above the national baseline used for these estimates, mainly on labor and permitting. Parts are priced nationally, so the spread between quotes usually comes from labor, brand and whether a repair or a replacement is recommended — ask for both numbers when a component is more than ten years old.
Photograph the pump, filter, heater and controller labels (model and serial). It saves a diagnostic visit and lets the tech bring the right parts.
PoolPad tracks 2 pool repair companies across Montana. PoolPad orders the list with a weighted score that combines customer rating and review count, so a long track record counts for more than a handful of scores.
Late-June openings in cooler valleys, attentive summer weeks, and a September close before the first hard freeze. With a thin service bench outside the metros, many owners self-serve chemistry with pro bookends. Freeze damage — cracked pump housings, split filter tanks and burst above-ground plumbing — is the classic spring repair here, and a documented winterization is the best defense.
Repair a component under about eight years old with a single failed part. Replace when the unit is older than ten years, when the repair is more than half the cost of a new one, or when a more efficient model — a variable-speed pump or a heat pump — pays back through lower Montana energy bills within a few seasons. Ask for both quotes and the expected life of the new unit.
A service call or diagnostic in Montana, MT typically runs $80–$160, often credited against the repair. Pump motor or seal work runs $325–$850; a new variable-speed pump installed $850–$2,650; heater repairs $150–$525 and a heater replacement $2,600–$6,800; filter rebuilds $150–$525; a new salt cell $550–$1,150. Montana labor is above the national baseline used for these estimates, mainly on labor and permitting. Get the repair and replacement price when equipment is more than ten years old.
Repair when the pump is under about eight years old and one part failed — a shaft seal, capacitor or lid o-ring is a $325-class fix. Replace when the motor is more than ten years old, the repair is more than half the cost of a new unit, or you are still running a single-speed pump: a variable-speed model typically cuts pump electricity by 50–80% and is required for most new installs under federal efficiency rules.
The most common causes are low water flow (dirty filter, closed valve or a failed pressure switch), a failed igniter or thermistor, a tripped high-limit switch, gas supply problems or a control board fault. Check filter pressure and valves first; if flow is fine, a heater technician can test the switches and board in one visit. Repairs typically run $150–$525, and units past 12–15 years are usually replacement candidates at $2,600–$6,800.
Pump motors typically last 8–12 years, filter cartridges 2–4 years, DE grids 5–10 years and filter tanks 15–25 years. Gas heaters last 10–15 years and heat pumps 10–20 with clean water and steady flow. Salt cells run 3–7 years depending on runtime and calcium scaling. Balanced water and clean filters are the cheapest way to reach the long end of those ranges.
The outdoor season in Montana runs mid-June through early September — about 3 months unheated. A full professional winterization each fall protects plumbing and equipment through the freeze, and spring openings cluster into the same few weeks. The unheated season runs mid-June through early September, with cool nights even in July. A heater materially extends use, and winters are long and hard-freezing statewide.
Aqua Systems Spa & Pool Technology, Inc. has the highest customer rating on this Montana list at 5 stars across 3 reviews. 5 Star Pool and Spa Service has the largest review count (37 reviews at 4.7 stars). PoolPad orders the list with a weighted score that combines customer rating and review count, so a long track record counts for more than a handful of scores.
Montana registers construction contractors at the state level — verify registration and insurance. Pool permits and residential-code barrier requirements run through your city or county building office; resort-town design review boards can add a step in places like Big Sky and Whitefish.
Often, yes. Most manufacturers give a longer warranty — commonly three years instead of one — when equipment is bought and installed through a qualified pool professional, and some void coverage for online purchases installed by the owner. Ask the repair company whether it is a warranty station for your brand and keep the installation invoice with the serial number.
If your property is near a state line, check the neighboring directories too.
Claim your free PoolPad listing, check the repairs and equipment work you handle, and show Montana pool owners with a broken pump or heater that you can fix it.
